Our Energy Storage Solutions
Discover our range of innovative energy storage products designed to meet diverse needs and applications.
- All
- Energy Cabinet
- Communication site
- Outdoor site
An insight into heat-induced gelation of whey protein isolate–lactose mixed and conjugate solutions: rheological …
It is known that protein/sugar conjugates prepared by Maillard reaction (MR) have good gel properties. However, there is not much information about the mechanism of MR on the gel properties of whey protein isolate (WPI). Electrophoresis confirmed the maximum molecular weight conjugate was obtained at incubation for 2 …
Viscoelasticity
Viscoelasticity is a physical phenomenon which stands for the structural nature of solids when undergoing deformation. Simplifying the elasticity is the result of the bond stretching in an ordered solid, while the viscosity …
Rheological and mechanical properties of ultrahigh molecular weight polyethylene/high density polyethylene/polyethylene glycol blends
The tan δ (the ratio of loss modulus to storage modulus) of the blends is always less than 1, which indicates that the UHMWPE/HDPE/PEG blends always exhibit elastic-dominated viscoelastic response over the experimental frequency range.
Quantifying Polymer Crosslinking Density Using Rheology and …
3 RH102 Figure 4. DMA temperature ramp tests on crosslinked elastomers with different crosslinking density To simplify the test method and shorten the measurement time, one can also program a short dynamic time sweep test at a temperature that is within the
Frequency-dependent transition in power-law rheological behavior of living cells | Science …
Meanwhile, the power-law exponent α of the storage modulus G′ is approximately the same as that of the loss modulus G″, both in the range of 0.1 to 0.3 in most experiments (6–9). However, as the frequency further increases, the weak power-law relationship breaks down, and the loss modulus G ″ shows a greater dependence on frequency than the storage …
Polymers and rheology: A tale of give and take
Oscillatory compression experiments to obtain the compression storage (elastic) modulus, K′, and the compression loss (viscous) modulus, K″, are much less employed, although they are of great interest in the field of physical gels, for instance hydrogels for96,
Experimental and molecular dynamics simulation study on …
In this study, the AAA-1 asphalt model was adopted to calculate the thermal (glass transition temperature), transport (self-diffusion), and rheological (viscosity, …
Rheological properties of concentrated polyacrylonitrile co …
Polyacrylonitrile copolymers with different molecular weights (Mws) are synthesised by aqueous free-radical redox polymerisation technique. Polyacrylonitrile (PAN) and lignin-blended solutions are prepared in dimethyl sulphoxide solvent by varying the polyacrylonitrile/lignin content. The effect of lignin addition to PAN copolymer having …
Relationship between Structure and Rheology of Hydrogels for …
Relationship between Structure and Rheology ...
Effects of pre-imidization on rheological behaviors of polyamic acid solution and thermal mechanical properties of polyimide film: an experiment ...
A series of polyamic acid (PAA) solutions and corresponding polyimide (PI) films with different chemical structures were prepared through a partial pre-imidization process, and the rheological behavior of PAA solutions and thermal mechanical properties of PI films were investigated in detail. The FT-IR spectra indicate that the pre-imidization …
Experimental and molecular dynamics simulation study on thermal, transport, and rheological properties of asphalt
The thermal (glass transition temperature), transport (self-diffusion), and rheological (viscosity, storage and loss modulus) properties of asphalt were studied with laboratory experiments and molecular dynamics simulations. The asphalt model employed in …
Miscibility, crystallization, mechanical, and rheological properties of poly (L-lactic acid)/poly(vinyl acetate) blends | Colloid and Polymer Science
The temperature dependence of storage modulus (E′) of neat PLA, neat PVAc, and PLA/PVAc blends with different PVAc contents is presented in Fig. 1b.The storage modulus is associated with the elastic response of the sample. For neat PLA, the highest E′ value was approximately 4.0 GPa and the E′ decreased drastically in the range …
A Basic Introduction to Rheology
WHITEPAPER 5 A Basic Introduction to Rheology attainable viscosity and is influenced largely by the solvent viscosity and related hydrodynamic forces. Model fitting The features of the flow curves shown in Figure 3 can be adequately modeled using some relatively
Analytical Rheology of Honey: A State-of-the-Art Review
Analytical Rheology of Honey: A State-of-the-Art Review
Analysis on the rheological behavior, microstructure and storage stability between crumb rubber of desulfurization and ...
2.1.2. Preparation of crumb rubber modified asphalt In this study, CRMA, DSCRMA and DPCRMA were prepared. The specific steps were as follows: (1) The virgin asphalt was heated in an oven (190 C) to the flow state, and …
Steady-State and Dynamic Rheological Properties of …
In the amplitude sweep and frequency sweep experiments, the energy storage modulus and loss modulus are enhanced with the decrease of temperature. These findings are helpful to …
Experimental and molecular dynamics simulation study on thermal, transport, and rheological properties of asphalt
The purpose of this study was to evaluate the thermal (glass transition temperature), transport (self-diffusion), and rheological (viscosity, storage and loss modulus) properties of asphalt via laboratory experiments and molecular dynamics simulations. A 12 ...
Buildings | Free Full-Text | Experimental Study on Dynamic Modulus …
Currently, the research on the mechanical properties of rubber-modified asphalt mixtures primarily focuses on small-scale investigations, with insufficient exploration into the performance of rubber particles and their relationship with the mechanism and properties of modified asphalt mixtures. Limited studies have been conducted on large …
A tutorial review of linear rheology for polymer chemists: basics …
G ′ is called the elastic or storage modulus because its contribution to the total stress is proportional to the strain, like a Hookean spring. G ′′ is called the viscous or …
4.3: Rheology
Exercise 4.3.1 Viscosity measurements are the realm of a field of science called rheology.Rheology is, literally, the study of flow. Another very simple definition, attributed to chemical engineer Chris Macosko at University of Minnesota, is the study of …
Rheology of hydrogels
The rheological properties were measured by a rheometer. The measuring program that was used was oscillatory test. The amplitude sweep was used to define the LVE range for hydrogels. From the LVE range, the …
Characterizing PSAs by Rheology | Adhesives
The failure energy - the area under the stress-strain curve - is a much more sensitive measure of tack compared to the height of the peak (maximum force) in the simple ASTM test 11 and also correlates …
Storage modulus (G'') and loss modulus (G") for beginners
Storage modulus (G'') and loss modulus (G") for beginners
Dynamic Mechanical Analysis Basic Theory & Applications …
DMA Applications and Data Interpretation
Storage modulus'' variation in aging and its application in …
ABSTRACT An investigation was performed into the stability of bulk emulsion explosive matrix (BEEM) via studying on the variation of storage modulus in aging. The experimental results show that there is a tight relationship between storage modulus (G′) and the stability of BEEM. The increase of the amount of ammonium nitrate …
Multiscale rheology model for entangled Nylon 6 melts
A multiscale simulation method is used to calculate the rheological properties of entangled Nylon 6 melts, including the stress relaxation modulus, storage and loss moduli, and the melt viscosity.
Memory effect in elastic modulus of a hydrogen-bonding polymer …
This paper yields experimental data about the transient change of the dynamic storage modulus G′ for a molten random copolymer of vinyl acetate and vinyl …
Analysis on the rheological behavior, microstructure and storage stability between crumb rubber of desulfurization and ...
Compared with traditional experimental methods, multiple parameters such as molecular structure, interaction forces, and energy changes help us better understand the interaction mechanism between CR and asphalt [26].
Rheological Property
Study of the rheological characteristics of polymeric blends and NCs in the molten state is critical to obtaining a fundamental understanding of the nature of the processability and structure–property correlation of NCs. Ahmed et al. (2010b) prepared PLA–NCs by blending l-PLA, PEG, and montmorillonite (MMT) clay by solvent cast technique.
Basic principle and good practices of rheology for polymers for ...
Basic consideration of the experimental methods using parallel-plate oscillatory rheometer and step-by-step guidelines for the estimation of the power law dependence of storage, …
The Rheology of Hot Melt Adhesives
Figure 2 shows typical curves for storage modulus (G''), loss modulus (G"), and loss factor (tan d) for a hot-melt adhesive, measured across a temperature range of -60 to +140 degrees C. At -60 degrees C, the material is an almost rigid solid, with the elastic portion (G'') predominant.
Rheological Property
To distinguish an uncross-linked polymer from a cross-linked polymer, researchers utilize the storage modulus (G′) and loss modulus (G′′) of polymer solutions [18]. To define the linear viscoelastic area in which the modulus G ′ and G ′′ are independent of the applied strain, samples are initially exposed to a strain sweep test [30] .